Powerbuilding: How to Train for Strength and Size Together
By Mac Burke, qualified sports nutritionist
The short answer
Powerbuilding combines heavy, low-rep work on the main lifts with higher-rep accessory training. Start each session with 3-5 sets of 3-6 reps at roughly 80-90% of 1RM on a squat, bench, deadlift or press. Then add 8-15 rep work to reach at least 10 hard sets per muscle each week.
Powerbuilding is a simple idea. Strength comes mostly from lifting heavy. Muscle comes mostly from doing enough hard sets. So you do both in the same week, often in the same session. Heavy compound lifts go first while you are fresh. Moderate-rep accessory work follows to build volume. You get stronger and bigger without picking one goal over the other.
Can you really build strength and muscle at the same time?
Yes. The two goals overlap a lot. A meta-analysis of 21 studies found that muscle growth was similar across light and heavy loads when sets were taken to failure, but 1RM strength improved more with heavy loads (Schoenfeld et al., 2017). That means heavy training builds muscle well too. It just adds a strength advantage on top.
The difference is mainly volume. In trained men doing 1, 3 or 5 sets per exercise three times a week, strength gains were similar across all groups, but muscle growth was greater with more sets (Schoenfeld et al., 2019). Strength responds to heavy, specific practice. Size responds to total hard sets. Powerbuilding covers both.
How is powerbuilding different from powerlifting or bodybuilding?
One study put this head to head. Trained men did either a bodybuilding routine of 3 sets of 10RM with 90 seconds rest, or a powerlifting routine of 7 sets of 3RM with 3 minutes rest, with total volume load matched. After 8 weeks, muscle growth was similar, but the powerlifting group gained more bench press strength (Schoenfeld et al., 2014). The catch is time. Seven sets with 3-minute rests takes far longer than three sets with 90-second rests.
Another study compared 4 sets of 3-5 reps at about 90% of 1RM with 4 sets of 10-12 reps at about 70%, in trained men over 8 weeks. The heavy group gained more lean arm mass (5.2% vs 2.2%) and more bench press strength (14.8% vs 6.9%) (Mangine et al., 2015). Powerbuilding takes the useful part of each style: heavy sets for the main lifts and efficient moderate-rep sets for volume.
How do you structure a powerbuilding session?
Order matters. Put the heaviest, most technical lift first. A typical session has three parts:
- Main lift: 3-5 sets of 3-6 reps at about 80-90% of 1RM, resting 3-5 minutes. Stop each set with 1-2 good reps left.
- Secondary lift: a variation of a main lift, such as a paused squat or close-grip bench, for 3-4 sets of 5-8 reps, resting 2-3 minutes.
- Accessories: 2-4 exercises for 2-4 sets of 8-15 reps, resting 1-2 minutes, taken within 0-2 reps of failure.
This follows the ACSM guidance: heavy 1-6RM loads with 3-5 minutes of rest for strength, and 6-12RM loads with 1-2 minutes of rest for hypertrophy (ACSM, 2009).
How many sets per week do you need?
For growth, more sets usually means more muscle, up to the point you can recover from. A meta-regression of 15 studies found each extra weekly set was linked to about 0.37% more muscle growth, and compared training groups at under 5, 5-9 and 10 or more sets per muscle per week (Schoenfeld et al., 2017). Aiming for at least 10 hard sets per muscle per week is a sensible target.
Heavy sets count toward that total. A set of 5 heavy squats is a hard set for your quads and glutes. So you do not need to add endless accessories. Count every hard set and fill the gaps.
What does a 4-day powerbuilding week look like?
An upper/lower split lets you train each main lift heavy once and each muscle twice a week:
- Day 1, lower heavy: back squat 4x4, Romanian deadlift 3x8, leg press 3x10-12, calf raise 3x12-15.
- Day 2, upper heavy: bench press 4x4, weighted chin-up 3x5-6, seated dumbbell press 3x8-10, cable row 3x10-12, triceps pushdown 2x12-15.
- Day 3, lower volume: deadlift 3x3-5, front squat or hack squat 3x6-8, walking lunge 3x10 each leg, leg curl 3x10-12.
- Day 4, upper volume: overhead press 4x5, incline dumbbell press 3x8-10, lat pulldown 3x10-12, lateral raise 3x12-15, curl 3x10-12.
Each session takes about 60-75 minutes. If you only have three days, a full-body version with one main lift per session works too.
Should you train to failure in powerbuilding?
Not on the main lifts. A meta-analysis of 15 studies found only a trivial advantage for training to set failure over stopping short for muscle growth, with an effect size of 0.19, and no clear advantage when only true momentary failure was compared (Refalo et al., 2023). A 2024 series of meta-regressions found strength gains were similar across a wide range of reps in reserve, while muscle growth improved as sets ended closer to failure (Robinson et al., 2024).
That fits the powerbuilding split neatly:
- Main lifts: stop with 1-3 good reps left. Heavy grinders add fatigue and injury risk for little extra strength.
- Secondary lifts: stop with 1-2 reps left.
- Accessories: go to 0-2 reps left, especially on machines and isolation exercises where failure is safe.
How do you progress a powerbuilding program?
Progress the main lifts and the accessories differently. On the main lifts, add a small amount of weight when you hit all prescribed reps with good form. The ACSM suggests a 2-10% load increase when you can do one or two reps over the target (ACSM, 2009). On accessories, use double progression: work up to the top of the rep range across all sets, then add weight and start back at the bottom.
Run a block for 4-8 weeks, then take a lighter week and reassess. If you want someone to adjust the plan each week based on your check-ins, that is what 1:1 coaching with Mac is for.
Common questions
Is powerbuilding good for beginners?
It can be, but beginners do not need the complexity. Simple full-body training with moderate loads builds both strength and muscle in the first months. Move to a powerbuilding structure once your technique is consistent and your gains start to slow.
Should I eat in a surplus for powerbuilding?
A small surplus helps if muscle gain is a priority, especially for leaner or more experienced lifters. You can still gain strength at maintenance. Keep protein high either way.
How long should I rest between heavy sets?
Rest 3-5 minutes on the main lifts so you can repeat the load with good form. Accessories need less, usually 1-2 minutes.
Can I do powerbuilding three days a week?
Yes. Use full-body sessions with one main lift each day, such as squat, bench and deadlift, plus accessories. Volume per muscle will be lower, so make each set count.
Sources
- Schoenfeld et al. (2014), Journal of Strength and Conditioning Research - Bodybuilding vs powerlifting-type training in trained men
- Mangine et al. (2015), Physiological Reports - Training volume vs intensity in resistance-trained men
- Schoenfeld et al. (2017), Journal of Strength and Conditioning Research - Low- vs high-load training meta-analysis
- Schoenfeld et al. (2017), Journal of Sports Sciences - Weekly training volume and muscle growth dose-response
- Schoenfeld et al. (2019), Medicine and Science in Sports and Exercise - Volume enhances hypertrophy but not strength
- American College of Sports Medicine (2009), Medicine and Science in Sports and Exercise - Progression models in resistance training
Ready to apply this to your own program?
MBM builds 1:1 coaching programs around the exact principles above - weekly check-ins, weekly adjustments, and a plan that fits your life.