← Back to blog
Muscle Gain· 5 min read

Does Rep Speed Matter for Muscle Growth?

By Mac Burke, qualified sports nutritionist


The short answer

Not much, within a normal range. A meta-analysis found reps lasting anywhere from 0.5 to 8 seconds built similar muscle when sets went to failure. Very slow reps, over about 10 seconds each, appear worse. Lower the weight under control, lift it with intent, and focus on effort and full range instead of a stopwatch.

You can lift fast or slow and still grow, as long as you control the weight and push the set hard. Rep speed is one of the least important variables for muscle growth. What matters far more is how close you get to failure, how many hard sets you do, and if you use a full range of motion. Speed only becomes a problem at the extremes: bouncing reps that skip range, or reps so slow you cannot use a meaningful load.

What does the research say about rep speed and muscle growth?

The clearest answer comes from a meta-analysis of eight studies that compared different rep durations, with all sets taken to failure. Muscle growth was similar for reps lasting from 0.5 to 8 seconds. The authors noted that training at volitionally very slow durations, more than 10 seconds per rep, appeared to be inferior for hypertrophy, though few studies have tested it (Schoenfeld et al., 2015).

A 2021 review of movement tempo reached a similar view. It found the research on tempo and hypertrophy is mixed and that many hypertrophy guidelines simply assume a self-chosen tempo (Wilk et al., 2021). In practice, most lifters naturally fall within that 0.5-8 second window.

Are super slow reps worse for building muscle?

Usually, yes, compared with normal-speed training, though the evidence is limited. Very slow reps force you to use a much lighter weight, so each rep moves far less load. In one 10-week study, sedentary women doing traditional-speed training improved total strength by 39%, compared with 15% for a superslow protocol (Keeler et al., 2001).

Another study in untrained women compared slow reps (10 seconds up, 4 seconds down) with normal-speed reps. The slow group did produce some fibre growth, but heavier training at normal speed, at about 80-85% of 1RM, produced the greatest overall muscle fibre response (Schuenke et al., 2012). Slow reps are not useless. They are just less efficient than lifting a heavier load at a normal pace.

Should you lift explosively?

Lifting with intent helps strength and does not seem to hurt growth. A meta-analysis of 15 studies found fast and moderate-to-slow training produced similar strength gains overall. At moderate loads of 60-79% of 1RM, there was a trend favouring fast training, with a small effect size of 0.31 (Davies et al., 2017).

In a 6-week squat study, trained men who pushed each rep as fast as possible improved maximum strength more than those who deliberately lifted at half speed, with effect sizes of 0.94 against 0.54. The authors concluded that movement velocity seemed more important than time under tension for strength gains (Pareja-Blanco et al., 2014).

Intent is the key word. Under a heavy load, the bar will still move slowly. What matters is that you try to drive it up hard, rather than deliberately slowing it down.

How fast should the lowering phase be?

Controlled, not rushed. A lowering phase of about 1-3 seconds keeps tension on the muscle and makes it easier to hit the same depth each rep. The ACSM recommends a moderate contraction velocity of about 1-2 seconds up and 1-2 seconds down for strength and hypertrophy work (ACSM, 2009).

  • Lowering: 1-3 seconds, under control, without dropping into the bottom.
  • Bottom position: a brief pause on lifts where bouncing is common, such as the bench press or squat.
  • Lifting: drive the weight up with intent. Let it slow down naturally as fatigue sets in.
  • Top position: no long rests at lockout, which let the muscle recover mid-set.

What does it mean when your reps slow down?

Slowing reps are a sign of fatigue, and that fatigue is part of what drives growth. In an 8-week squat study, one group stopped each set when bar speed dropped by 20%, and another kept going until it dropped by 40%. Strength gains were similar, and the 20% group improved jump height more (9.5% vs 3.5%) despite doing 40% fewer reps. But the 40% group grew two of the quad muscles more (Pareja-Blanco et al., 2017).

So for strength and power, stopping before reps slow down a lot works well. For muscle, pushing on until reps slow noticeably is useful, as long as range and form hold. Either way, the slowdown should come from fatigue, not from you deliberately lifting slower.

When does rep speed actually matter?

Speed causes problems when it changes the rep itself. Fast, sloppy reps often cut range, use momentum, or bounce out of the bottom. That turns a hard set into an easier one. Range matters for growth: a meta-analysis of 16 studies found full range of motion produced greater strength and lower-body muscle growth than partial range (Pallares et al., 2021).

So the real rule is this: pick a speed that lets you control every rep through the same full range. If you go faster and the range stays the same, you are fine. If going faster means shallower reps, slow down. Move IQ in the MBM app, launching soon, uses your phone camera to count reps and flag ones that miss your target range, which is useful when fatigue makes reps quicker and shorter. Early access is at /app.

Can slow reps help in some situations?

Yes. Slow reps make light weights more challenging. In one 12-week study, untrained men doing knee extensions at about 50% of 1RM with 3-second lifting and lowering phases grew their quads and gained strength, as did a group lifting about 80% at normal speed. A light-load, normal-speed group matched for work did not (Tanimoto and Ishii, 2006). That makes slower tempos useful at home with limited equipment, when returning from injury on a professional's advice, or when learning a new movement.

Common questions

Is a 3-1-1 tempo better for muscle growth?

Not clearly. Any tempo where a rep takes roughly 0.5-8 seconds builds similar muscle when sets are hard. A set tempo can be useful for consistency and technique, but it is not required.

Does lifting faster burn more calories?

Slightly, if it means more work in less time, but the difference is small. For fat loss, total training, daily activity and diet matter far more than rep speed.

Should I pause at the bottom of each rep?

A brief pause helps on lifts where bouncing is common, such as the bench press and squat. It removes momentum and keeps reps honest. You do not need to pause on every exercise.

Why do my reps slow down near the end of a set?

Fatigue reduces how much force your muscles can produce, so the bar moves more slowly. Slowing reps are a useful sign you are getting close to failure.

Sources

  1. Schoenfeld et al. (2015), Sports Medicine - Repetition duration and muscle hypertrophy meta-analysis
  2. Davies et al. (2017), Sports Medicine - Movement velocity and dynamic muscular strength meta-analysis
  3. Pareja-Blanco et al. (2014), International Journal of Sports Medicine - Movement velocity and neuromuscular performance
  4. Wilk et al. (2021), Sports Medicine - Movement tempo, strength and hypertrophy: a review
  5. Keeler et al. (2001), Journal of Strength and Conditioning Research - Traditional-speed vs superslow resistance training
  6. Pallares et al. (2021), Scandinavian Journal of Medicine and Science in Sports - Range of motion and training adaptations meta-analysis
Work with Mac

Ready to apply this to your own program?

MBM builds 1:1 coaching programs around the exact principles above - weekly check-ins, weekly adjustments, and a plan that fits your life.

Keep reading

← More posts on the MBM blog