← Back to blog
Training· 5 min read

Progressive Overload: How to Actually Do It

By Mac Burke, qualified sports nutritionist


The short answer

Progressive overload means making the same exercise harder over time so your body keeps adapting. The simplest method is double progression: work in a rep range, add reps until you hit the top of it on every set, then increase the load by about 2-10% and start again at the bottom of the range.

Your body adapts to what you ask of it, then stops changing. Progressive overload is the fix. Each week or two, do a little more than last time: one more rep, a bit more weight, or an extra set. Small, steady jumps beat big ones. And adding weight is not the only option, which matters once the easy beginner gains slow down.

What counts as progressive overload?

Anything that raises the demand on the muscle while form stays the same. The main levers are:

  • More reps with the same weight.
  • More weight for the same reps.
  • More hard sets per week.
  • Same weight and reps, but with fuller range of motion or a slower, more controlled lowering.

What does not count: the same session, done the same way, with sloppier form so the number goes up. If range of motion shrinks or you start bouncing reps, you have not progressed.

Is adding reps as good as adding weight?

For muscle growth, it seems so. In an 8-week study of 43 lifters with at least a year of training, doing 4 sets of 4 lower-body exercises twice a week, one group increased load while keeping reps fixed. The other kept load fixed and added reps. Muscle growth was similar, with a slight edge for the reps group in the rectus femoris. Strength slightly favoured the load group, by about 2 kg on the squat, a difference the authors called of questionable practical significance (Plotkin et al., 2022).

That is good news. On exercises where the smallest weight jump is large, like dumbbell lateral raises going from 7 kg to 9 kg, you can add reps for weeks before moving up.

It also helps with home workouts, where your heaviest dumbbell sets a ceiling. Once you can do 20-25 reps, switch to a harder variation, slow the lowering to 3 seconds or add a pause at the bottom.

How much weight should I add and when?

The American College of Sports Medicine recommends a 2-10% load increase once you can do one or two reps more than your target with the current weight (ACSM, 2009). In practice:

  • A 100 kg squat: 2-10% is a 2-10 kg jump. Start at the small end.
  • A 60 kg bench press: 2-10% is about 1.2-6 kg, so 1.25-2.5 kg jumps make sense.
  • Small exercises (curls, raises): add reps first, then the smallest jump available.

Smaller jumps are easier to absorb. If you jump from 60 kg to 70 kg on the bench and your reps fall from 10 to 4, you have dropped out of your range. A 2.5 kg jump might cost only a rep or two.

What is double progression and how do I run it?

Double progression combines reps and load. It works for almost any exercise and needs nothing more than a training log.

  • Pick a rep range, such as 8-12, and a weight you can lift for 8 reps on all sets with 1-3 reps in reserve.
  • Each session, try to add a rep to one or more sets.
  • When you hit 12 reps on every set, add weight.
  • With the heavier weight you will drop back to around 8 reps. Build back up to 12 and repeat.

Example: 3 sets of 40 kg on a machine chest press. Week 1: 8, 8, 8. Week 3: 10, 10, 9. Week 6: 12, 12, 12. Week 7: add weight and go 9, 8, 8.

What if I cannot add reps or weight anymore?

Check the basics first. Stalls usually come from poor sleep, low food intake or stopping sets too far from failure. If those are fine, use the other levers.

  • Add a set. Higher weekly volume tends to produce more growth. In one study, trained men doing 5 sets per exercise grew more than those doing 1 or 3 sets (Schoenfeld et al., 2019).
  • Widen the rep range, for example from 8-12 to 8-15.
  • Change the exercise variation and start a fresh progression.
  • Take a lighter week, then build back up.

Change one lever at a time and give it a few weeks. If you add a set, change the exercise and eat more all at once, you will not know what worked.

What mistakes stop progressive overload working?

  • Adding weight while form gets worse. Shorter reps and more body swing mean the muscle is doing less, not more.
  • Jumping too far. A big load jump that drops you below your rep range leaves you stuck there for weeks.
  • Changing exercises every week. You never stay on one long enough to progress it.
  • Not writing anything down. Memory is poor at telling 22.5 kg from 25 kg, or 9 reps from 10.
  • Ignoring recovery. If sleep and food are poor, numbers stall no matter how clever the plan.

Most stalls in the first year come from one of those five, not from the program itself. Fix them before you reach for a new routine.

How do I track progressive overload?

Write down every working set: exercise, weight, reps and how many reps you had left. A notes app works. So does a paper notebook. The method matters less than doing it every session. Before each session, look at last time and set a target to beat by one rep or a small load increase. You will not beat it every session, but you should beat it most weeks across a training block.

Track form as well as numbers. A rep that only goes halfway down should not count. Move IQ in the MBM app uses your phone camera to count reps and flag reps that miss range, so your logged numbers reflect real reps. The app is launching soon, with early access open.

Common questions

How fast should I progress?

Beginners can often add load most sessions on big lifts for the first few months. Intermediate lifters might progress weekly or every few weeks. Slower progress over time is normal.

Can I progressively overload with home workouts?

Yes. Add reps, slow the lowering phase, pause at the bottom, use harder variations like single-leg work, or add sets. Bands and adjustable dumbbells give more load options.

Do I need to add weight every week?

No. Adding a rep counts. So does doing the same weight with better form or more control. Forcing weight up every week usually breaks form.

Is progressive overload the same as training to failure?

No. Failure is about effort within a set. Progressive overload is about doing more over weeks. You can progress while keeping 1-3 reps in reserve.

Sources

  1. Plotkin et al. (2022), PeerJ - Progressive overload without progressing load
  2. American College of Sports Medicine (2009), Med Sci Sports Exerc - Progression models in resistance training
  3. Schoenfeld et al. (2019), Med Sci Sports Exerc - Training volume enhances hypertrophy but not strength
Work with Mac

Ready to apply this to your own program?

MBM builds 1:1 coaching programs around the exact principles above - weekly check-ins, weekly adjustments, and a plan that fits your life.

Keep reading

← More posts on the MBM blog